PolySwitch(R) PTC Devices PRODUCT: AGRF800 Overcurrent Protection Device 308 Constitution Drive Menlo Park, CA 94025-1164 Phone: 800-227-4856 www.circuitprotection.com Raychem Circuit Protection Products DOCUMENT: SCD 25235 PCN: A95482 REV LETTER: B REV DATE: MAY 8, 2007 PAGE NO.: 1 OF 2 Specification Status: RELEASED Electrical Rating Voltage: 16VDC MAX Insulating Material: Cured, Flame Retardant Epoxy Polymer Lead Material: 20 AWG Tin Plated Copper (0.8 mm [0.032] nom. diameter) Part Marking: Manufacturer's Mark and Voltage 16 Part Identification GF8 Lot Identification (can be on back) TABLE I. INSTALLATION ENVELOPE DIMENSIONS: A mm: in*: B MIN MAX MIN MAX -12.7 -22.2 -(0.50) -(0.88) *Rounded off approximation C MIN 4.3 (0.17) D MAX 5.8 (0.23) MIN 7.6 (0.30) E MAX --- MIN --- MAX 3.0 (0.12) F TYP 1.2 (0.05) G MIN MAX -5.08 -(0.200) TABLE II. PERFORMANCE RATINGS: CURRENT RATINGS TIME TO TRIP AMPS SECONDS AT 25C AT 25C, 40 A HOLD HOLD TRIP MAX AT AT R1 MAX RA MAX 8.0 7.6 15.0 5.5 Reference Documents: Precedence: Effectivity: CAUTION: INITIAL RESISTANCE OHMS AT 25C MIN MAX 0.0049 0.0113 OHMS AT 25C 0.0175 0.0181 TRIPPEDSTATE POWER DISSIPATION WATTS AT 25C TYP 3.2 PS400, PS300 (reference for R1 MAX) This specification takes precedence over documents referenced herein. Reference documents shall be the issue in effect on the date of invitation for bid. Operation beyond the rated voltage or current may result in rupture, electrical arcing or flame. Materials Information ROHS Compliant RA MAX R1 MAX 1 HR. POST TRIP RESISTANCE STANDARD TRIP OHMS AT 25C ELV Compliant (c) 2004, 2007 Electronics Corporation. All rights reserved. Pb-Free PolySwitch(R) PTC Devices 308 Constitution Drive Menlo Park, CA 94025-1164 Phone: 800-227-4856 www.circuitprotection.com Overcurrent Protection Device Raychem Circuit Protection Products PRODUCT: AGRF800 DOCUMENT: SCD 25235 PCN: A95482 REV LETTER: B REV DATE: MAY 8, 2007 PAGE NO.: 2 OF 2 TABLE III. AUTOMOTIVE SPECIFIC STRESS TESTS AND TEST CONDITIONS: ELECTRICAL STRESS TESTS TEST CONDITIONS (see note 2) ESD Voltage Withstand (see note 1) Short Circuit Fault Current Durability 25kV Fault Current Durability 350 cycles, 16V/100A End-of-life Mode Verification 1750 cycles, 16V/100A Jump Start Endurance (see note 1) Load Dump Endurance (see note 1) 3 cycles, 26V, 1 minute duration 25 cycles, 16V, 200A 10 cycles, 86.5V Note 1: The PolySwitch devices are tested in series with a load resistance and the voltages specified in the test conditions are shared between the PolySwitch device and the load resistance as specified in PS400. Note 2: Please refer to Appendix A of PS400 for the detailed test procedures